The Piedmont region placed under a flood advisory until Tuesday evening

The creation of this content included the use of AI based on templates created, reviewed and edited by journalists in the newsroom. Read more on our AI policy here.

On Tuesday at 2:52 p.m. the NWS Raleigh NC issued a flood advisory in effect until 6 p.m. The advisory is for Anson, Montgomery and Richmond counties.

The NWS informs, "Flooding caused by excessive rainfall is expected."

"Minor flooding in low-lying and poor drainage areas," describes the NWS. "Turn around, don't drown when encountering flooded roads. Most flood deaths occur in vehicles."

This advisory is in effect until 6 p.m.

Recommendations from the NWS for staying safe during a flood

If you live in a flood-prone area or are camping in a low-lying area, get to higher ground immediately. If told to evacuate, do so immediately. Lock your home when you leave. If you have time, disconnect utilities and appliances. Don't go into a basement, or any room, if water covers the electrical outlets or if cords are submerged. If you see sparks or hear buzzing, crackling, snapping, or popping noises, get out. Stay out of water that may have electricity in it. Don't walk through flood waters. It only takes 6 inches of moving water to knock you off your feet. If you are trapped by moving water, move to the highest possible point and call 911 if possible.

When heavy rain occurs, there is a potential for flooding, particularly in areas that are low-lying or prone to floods. It is crucial to never drive through water on the road, even if it appears shallow. According to the NWS, as little as 12 inches of fast-flowing water can carry away most vehicles.

Rainy weather driving tips

• Turn on headlights - Even in daylight, using headlights can help improve visibility and let other drivers know where you are.
• On the road - Drive in the middle lanes and stay on high ground. Rainwater tends to stockpile on the edges of roads.
• Keep clear of puddles - Driving through puddles or low rainwater areas can cause vehicles to hydroplane or skid out of control
• Don't tail large vehicles closely - Trucks or buses can kick up a water spray that obstructs visibility.
• Avoid flooded areas - When encountering a flooded road, do a U-turn and head back. The strong currents from flash floods can pull drivers off roadways. Driving through deep water can also negatively affect a vehicle's mechanical and electrical systems.

What is hydroplaning?

Hydroplaning happens when a vehicle starts sliding uncontrollably on wet roads.

This happens when water in front of the tire builds up faster than the vehicle's weight can push water out of the way. The water pressure then causes the vehicle to rise and slide on a thin layer of water between the tires and the road, making the driver lose control. Hydroplaning is primarily caused by three factors:

1. Vehicle speed - When a vehicle's speed increases, the tire-traction grip and ability to control the vehicle decreases. Drive at a reduced speed during wet weather.
2. Water depth - The deeper the water, the sooner a vehicle loses traction on the road. It doesn't matter how deep the water is, even a thin layer can lead to hydroplaning.
3. Tire tread depth - Checking your tire tread before hitting the road is important, as low or no tread can lead to sliding.

In the event of your vehicle hydroplaning, here's what to know:

• Ease off the accelerator - Step off the gas to slow down the vehicle until the tires find traction.
• Turn into the skid - Turning into the skid can help the vehicle's tires realign to regain control.
• Make sure the tires reconnect with the road - During the skid, wait until the tires reconnect with the road and then gently straighten the wheels to regain control.
• Brake gently as needed - Brake normally if the vehicle has anti-lock brakes and pump brakes gently if in an older vehicle.

Source: The National Weather Service

United Robots North Carolina

This story was originally published May 26, 2026 at 2:54 PM.